I opened this discussion forum from Captivate but I really need Prime. Sorry if this is in the wrong place!
A couple of open issues/questions:
1) When I preview a Captivate deck I am able to use the ‘next’ button to navigate to the next slide. However, when I upload the course to Prime and view it, the ‘next’ button goes to the next MODULE, not the next slide in the current module.
2) When I view the table of contents of a course in Prime, there are several slide icons that have a “?” in them. I’m assuming this is supposed to indicate the slide is either a knowledge check or quiz, however, that’s not the case for several of my slides — and no, they were not created as quiz/knowledge check and then changed to standard slides.
Thanks!
- Captivate Prime uses what is called a Fluidic Player. Are you sure that you are using the controls of your published project and not those of the Prime Fluidic Player? What you described sounds like the player controls through the entire course rather than your project controls.
- I don’t have an answer for the second point. I do not use the built-in table of contents in my projects. Perhaps another can weigh in on that one.
You can perfectly post your Prime question here in the eLearning community. It is not at all limited to Captivate questions. Sorry, not to be able to help you, I am not using Prime but cross my fingers that a Prime expert will offer support.
You must be logged in to post a comment.
